Primer FL-03K

Appointment (FL-03K)

Primer FL 03K has found wide application in metallurgy. It is applied to the surface of ferrous metals and titanium alloys. Also used for priming wood surfaces. Retains its protective properties in a temperate, cold and tropical climate.

Application

Before use, the FL-03K primer should be stirred to a uniform state throughout the entire volume of the container, then add desiccant and dilute to the working viscosity with solvent, xylene, or the consistency of one of the indicated solvents with white spirit in a 1: 1 ratio by weight. For coloring in the electric field for diluting the primer FL 03K apply diluent RE-4B. Apply primer to the surface by spraying, dipping or brushing. In addition, the jetting method is allowed. For priming steel surfaces in the coating system with enamels HV-124, XB-16 it is allowed to use the primer FL-03K without the additional introduction of desiccant. The primer is applied to the surface at temperatures from -10 ° C to + 30 ° C.

The thickness of one layer of primer – 15-20 microns. Primer consumption on one layer when drawing by pneumatic spraying of-60-80 g / m ², airless dispersion –

57-75 g / m², in the electric field -50-67 g / m², with a brush -50-67 g / m². Work in personal protective equipment using a respirator and rubber gloves. To the workplace to ensure a constant flow of fresh air. It is forbidden to work near an open source of fire.

Specifications (FL-03K)

No	Name of the indicator	Value
one	Conditional viscosity according to the viscometer of the type VZ-246 with a nozzle diameter of 4 mm, at a temperature of (20.0 ± 0.5) ° C not less, (s)	40
2	The degree of dilution with a solvent, not more (%)	25
3	Mass fraction of nonvolatile substances, (%)	61 ± 3
four	Milling degree, no more (micron)	40
five	Drying time to degree 3 at a temperature of (20 ± 2) ° С, (h)	eight
6	Drying time to degree 4 at a temperature of (105 ± 5) ° С, (min)	35
7	Film hardness after drying at a temperature of (20 ± 2) ° С using a pendulum device not less than	M-3 – 0.36 (used); TML (pendulum A) – 0.2 (relative units)
eight	Film hardness after drying at a temperature of (105 ± 5) ° С using a pendulum device, not less	M-3 – 0.5 (used); TML (pendulum A) – 0.3 (relative units)
9	Bending elasticity of the film, not less, (mm)	one
ten	The strength of the film upon impact, (cm)	50
eleven	Adhesion of film, not more, (points)	one
12	The resistance of the coating at a temperature of (20 ± 2) ° С to the static effect of a 3% solution of sodium chloride (h):	24
13	The resistance of the coating at a temperature of (20 ± 2) ° C to the static effect of industrial oil (h):	72
14	Grinding capacity	The coating when grinding should form a flat surface and do not pickle the skin.

Warranty period of storage – 6 months from the date of manufacture.