Specifications:
| No | The name of indicators | Requirements TNPA |
| one | Markings material | Uniform surface without cracks, blisters or delaminations |
| 2 | Mass fraction of nonvolatile substances,%, not less | 75 |
| 3 | Consumer viscosity according to VZ-246 viscometer with a nozzle diameter of 4 mm at a temperature of (20.0 ± 0.5) ° C, s | 80 – 160 |
| four | Milling degree, µm, not more | 70 * |
| five | Drying time (hardening), min, at a temperature of (20 ± 2) o C, to degree 2 | 5 – 10 |
| 6 | Hookability of dried film, g / m 2 , not more | 220 |
| 7 | Film hardness by pendulum device TML (pendulum A), relative units, not less | 0.20 * |
| eight | 8 Diffuse reflection coefficient (brightness coefficient, whiteness ) by FB- 2 photoglossometer,%, for color: white, not less yellow, not lessorange, not less no more black |
87
40 thirty ten |
| 9 | Flexural elasticity of the coating on the rod with a diameter of mm, not more | 10 * |
| ten | Coating frost resistance, cycles, not less | ten |
| eleven | Density, g / cm 3 , not less | 1.5 |
| 12 | Adhesion to asphalt concrete and cement concrete, N / cm, not less | 6.0 |
| * Not standardized for orange enamels | ||
Advantages : Enamel has good whiteness, high hardness, elasticity, sedimentation resistance, fast drying, excellent resistance to wear. It is clear that there is no trace of it.
For the road markings, it is necessary to remove the old markings. Enamel is a clean, dry, cleaned from dirt and dust pavement. The road surface is cleaned from one or three passes in one track. Unprepared or wet coating is not allowed. Before use, the enamel should not be thoroughly mixed. If necessary, the enamel is diluted with solvent R-555 (produced by JSC “Lakokraska”
TU BY 500021625.150-2010) in an amount of not more than 3% by weight of the paint. Enamel is applied to the air temperature and air temperature, it is not less than 85%. cases by brush or roller. By marking lines is allowed no longer than 30 minutes after their application. Under drying conditions. The film must be at least 600 microns,
It is not recommended to arrange a permanent marking on newly laid road surfaces or protective layers earlier than 1 month after their installation.
With open movement and traffic intensity of more than 3000 cars / day, a permanent marking device is allowed after 1 week.
It is necessary to ensure that it can be used for a few days after marking, and it is necessary to additionally spray it with a diameter of 150 to 500 μm (up to 30% of enamel mass). It has been noted that the distribution of the marking machines has been carried out. It is no longer than 10 s after the application of the material.
Enamel consumption: from 600 g / m² (depending on the type of coating, the thickness of the coating, and the method of application).
P-555.
Storage: Enamel is stored in a sealed container, avoiding direct sunlight at a temperature of 5 ° C. and not higher than + 30 ° C. Keep away from fire! Transportation regulations in compliance with current standards and fire safety regulations.
The Measures Precautionary: the To protect skin of phone hands to the apply a rubber gloves. It doesn’t have a chemical effect.
