General purpose alkyd primer is applied before applying enamel on metal and wood surfaces. When storing the GF-021 “L” in the container does not form a precipitate and film, this effect was made possible by the addition of special additives. After applying the ball primer retains its protective properties at temperatures from -45 ° C to + 60 ° C.
Used for dyeing metal and wooden products and structures for coating various enamels. It can be used for surfaces that are used both indoors and outdoors. The primer layer has protective and adhesive properties. Application of Primer GF-021 significantly reduces the consumption of enamel during painting.
The surface must be dry, free from dirt, dust, corrosion and old paint. Before using, the primer GF-021 and GF-021 “L” should be thoroughly mixed over the entire volume of the container and diluted to a working viscosity of 22-24 seconds according to VZ-246 (4mm nozzle) with solvent, xylene, nephras A 120/200 or with the consistency marked solvents with white spirit (nefrasy C4 155/200) in the ratio 1: 1.
The primer can be applied by pneumatic spraying, brushing, dipping or spraying in an electrostatic field in 1 layer. When coloring in the electric field add diluent RE-4B. The thickness of the 1st layer of primer 15-20mkm. Primer consumption on a single-layer coating – (60-100) g / m ?. The temperature of the air where the product is painted should be at least 15 ° C, the relative humidity should not exceed 80%. To the workplace to ensure a constant flow of fresh air. Do not carry out work near an open source of fire.
The name of indicators | Norm | |
Primer film color | Red-brown, light gray, shade not standardized | |
The appearance of the film | After drying, the film should be smooth, uniform, matte or semi-glossy. | |
Conditional viscosity at a temperature of (20 ± 0.5) ° С, according to viscose metric VZ-246 with a nozzle diameter of 4 mm, s, not less | GF-021 “l” | GF-021 |
45 | 45 | |
The degree of dilution of the primer solvent,%, not more | 20 | 20 |
Mass fraction of nonvolatile substances,% | 58 ± 3 | 54-60 |
Milling degree, µm, not more | 40 | 40 |
Drying time to degree 3, no more at a temperature of (105 ± 5) ° С, min
(20 ± 2) ° С, h |
3524 | 3524 |
Film hardness by pendulum device type TML (pendulumA), relative units, not less
Type M-3, standard units, not less |
0.15— | —0.35 |
Flexural elasticity, mm, not more | one | one |
The strength of the film when struck on the device type U-1, cm, not less | 50 | 50 |
Adhesion of film, points, not more | one | one |
Film resistance to static effects at (20 ± 2) ° С, h, not less
-3% sodium chloride solution – mineral oil |
2448 | 2448 |
The ability of the film to be sanded | When grinding the film should form a flat surface and do not pickle the skin | |
Film resistance to nitroenamel exposure | There should be no peeling, wrinkling, cracking of the nitro-enamel film. | |
Delamination, ml, not more | five |