Products

Primers VL-023
September 1, 2018
Primer GF-021
September 1, 2018

Primers GF-0119

Primer GF 0119 is a suspension of pigments and fillers in an alkyd varnish with the addition of siccative solvents and stabilizing substances. Warranty period of storage 6 months from the date of manufacture. 

Category:

Назначение ( ГФ-0119 )

Грунтовка ГФ 0119 имеет красно-коричневый цвет и нашла широкое применение.

Грунт можно наносить на деревянные и металлические поверхности для их подготовки перед покраской или для консервации на период хранения или монтажа. Покрытие грунтовки сохраняет свои защитные свойства при перепаде температур от -50°С до +60°С.

Применение

Перед применением грунтовку ГФ 0119 тщательно перемешать по всему объему тары.

If there is a need, it can be diluted with solvent, CP-2 solvent or a mixture of white spirit solvent (nefras C4 –155/200) in a 1: 1 ratio by weight.

The painted metal surface must be pre-cleaned from corrosion by sanding and degreased with a solvent.

The primer is applied with a brush, dipping, spray coating, spraying methods. Drying time at a temperature of (20 + 2) ° С – no more than 12 hours, at a temperature of (105 + 5) ° С – no more than 35 minutes. Work in personal protective equipment using a respirator and rubber gloves. Prevent material from entering the respiratory and digestive organs. To the workplace to ensure a constant flow of fresh air. Do not carry out work near an open source of fire.

Specifications (GF-0119)

Name of the indicator Value
Primer film color Red brown. Hue is not standardized
The appearance of the film primer After drying, the film should be smooth, uniform.
Primary viscosity of the primer at a temperature of (20 ± 0.5) ° С, according to the viscometer VZ-246 with a nozzle diameter of 4mm, s 60-100
Mass fraction of nonvolatile substances,% 53-59
The degree of dilution of the primer solvent,%, not more 25
Milling degree, µm, not more thirty
Drying time to degree 3, no more at a temperature of (105 ± 5) ° С, min, (20 ± 2) ° С, h 3512
The hardness of the film on a pendulum device type TML (pendulum A), rel. units non-type M-3, standard, no less 0,150.35
Flexural elasticity of the film, mm, not more one
Film durability at impact on a device of type U-1, cm, not less 50
Adhesion of film, points, not more eleven
The ability of the film to be sanded When sanding, the film should form a flat surface and not fill the skin
13. Film resistance to static exposure at a temperature of (20 ± 2) ° С, h, at least -3% sodium chloride-water solution

industrial oil

48144240
14. Film resistance to nitroenamel action. There should be no peeling, wrinkling, cracking of the film applied on the primer
15. Delamination, cm ?, no more five 
up