Enamel HS-558

Purpose (XC-558)

Enamel is made only in white color. Paint differs in durability, full water tightness. It has high resistance to mechanical, electrical and electrostatic loads. High resistance to aggressive gases and alcohol. Temperature of -30 ° C to + 60 ° C. C.C. -558C. , milk, drinking water, juices and fruits.

 

Application

 

Before the volume of the container. The enamel should be diluted with solvent P-4, P-4A using a VZ-246 type viscometer (4mm nozzle). Enamel spraying on primer XC-04 in 2-4 layers. Enamel consumption on 4 layers – 600 g / m? Drying of water is heated to 60 ° C until complete recovery is achieved. Work in personal protective equipment using a rubber gloves. Do not allow paint to enter the respiratory and digestive organs. Do not carry out work.

 

Technical characteristics (XC-558)

 

Name of the indicator	Norm
	HS-558	HS-558 “B”
The appearance of the film	Homogeneous smooth surface without foreign inclusions
Color enamel film	White, shade is not standardized
Enzyls VZ-246 with a nozzle diameter of 4mm at a temperature of (20 ± 2) ° C, s	30-80	30-80
Mass fraction of nonvolatile substances,%	37 ± 2	37 ± 2
Enamel milling degree, µm, not more	thirty	thirty
Drying time to degree 3 at a temperature of (20 ± 2) ° С, h, not more	3	3
Flexural elasticity of the film, mm, not more	one	3
If necessary, it is possible to reduce the amount of 96% at a temperature of (20 ± 2) ° C, hours, not less	2	2
Film hardness by pendulum device type TML (mA), relative units, not less	0.2	0.2
Film durability U-1, cm, not less	50	40
Adhesion of film, points, not more	2	2
Milling degree, µm, n / b	thirty	thirty