Enamel URF-1128

SPECIFICATIONS:

The appearance of the coating	After drying, it must be a smooth, uniform, smooth, glossy surface without any inclusions. Small shagreen is allowed.
Enamel coating color	Hue is not standardized. Must be established for the samples.
red	6.46
blue	427,428
yellow	223,287
green	Color control samples
Conventional viscosity with a nozzle diameter of 4 mm at a temperature of (20.0 + 0.5) 0 С, s, no less	50-90
Mass fraction of nonvolatile substances,%
black	45 + 3
green blue	52 + 3
white, red, yellow	57 + 3
Milling degree, µm, not more	20
Drying time to degree 3, h, not more, at a temperature:
(20+ 2) оС	6
(80+ 2) оС	0.5
Hiding power of dried film, g / m2, not more than for enamels:
black	60
red, blue, green	95
white yellow	130
Flexural elasticity of the film, mm, not more	one
Adhesion of film, points, not more	2
Film hardness, relative units, not less, by pendulum device: TML (pendulum A)	0.25
Gloss of film,%, not less	55
Coating strength at impact on U-1 device, cm, not less	50

 

APPLICATION:

Xylene, solvent or white spirit. It can be used from 35–40 s.

 

Enamel consumption – 60-100 g / m2 for a single-layer coating.

Enamels are applied to the pre-primed surface by spraying or brushing.

 

Enamels are used on FL-03K, GF-021, AU-021 and EF-065.

 

STORAGE:

Warranty storage period – 6 months from the date of manufacture.