CONTOUR 98 Silicone Sanitary

Properties:
good adhesion to non-porous surfaces: glass, ceramics, steel, aluminum and plastics. Elastic. Resistant to moisture, UV rays, detergents. Not painted. Not applicable to marble, concrete, plaster, decorative stone (granite, sandstone, etc.), copper and its alloys, polyethylene, bitumen, rubber; materials, emitting oils and solvents. Not recommended for gluing mirrors, gluing and sealing aquariums. Not intended for products in contact with food and for medical purposes.

Technical data

Consistency	sticky paste
Curing system	acidic
Density	0.96 g / cm?
Working temperature	+ 5 ° С / + 40 ° С
Film formation time	10-20 minutes
Cure time	about 2.5 mm per day **
Storage temperature	+ 5 ° С / + 25 ° С
Shelf life	24 months
After curing
Modulus of elasticity at 100% elongation	0.25 MPa (ISO 8339)
Tensile elongation	150% (ISO 8339)
Stretching to break	0.35 MPa
Allowable deformation	± 20%
Change in volume	<10% (ISO 10563)
Recovery of elasticity	> 90% (ISO 7389)
Shore A hardness	12
Heat resistance	-40 ° С / + 100 ° С

Application:
clean, degrease and dry the surface. Trim the cartridge above the thread. Cut off the tip to the width of the seam and screw it onto the cartridge. Extrude with a pistol. Smoothing the seam with a soap and water solution is allowed.

Attention!
S2 Keep out of the reach of children. S24 / 25 Avoid contact with skin and eyes. S26 In case of contact with eyes, rinse immediately with plenty of water and seek medical advice. S51 Use only in well-ventilated areas.

Logistic information

packing	packaging	number on pallet	Colour	barcode	gross weight
plastic cartridge with tip and cap	cardboard box	120 boxes	transparent	pieces 4820085760127	pieces 0,290
			white	4820085760110	0.320 kg
280 ml	12 pcs. In the box	1440 pcs.	transparent	drawer 4820085763593	box of 3,680 kg
			white	4820085763586	4,040 kg

Notes.
The recommended minimum joint width should be 6 mm. For joints between 6 and 12 mm wide, the recommended depth is 6 mm. In the case of a seam width of more than 12 mm, the ratio of width to depth A: B should be 2: 1, to max. depth 12 mm. In the case of deeper seams, as well as where it is necessary, a polyethylene cord should be used, with a minimum layer thickness of 6 mm. The polyethylene cord should be used wherever return stress can protrude or to avoid adherence to three surfaces, which limits the sealant’s adaptation to movement.