Enamel MS-249
October 2, 2018Enamel MCH-123
October 2, 2018
Enamel MS-17
Composition
Enamel MS-17 is a suspension of pigments in a solution of alkyd-styrene varnish in xylene with the addition of desiccant. This enamel has a high drying rate, resistance to the action of water, mineral oils, temperature changes, as well as good electrical insulating properties. Coatings treated MS 17 are operated in areas with a temperate climate under a canopy and inside heated and unheated rooms.
Purpose (MS-17)
Enamel MS-17 is widely used in mechanical engineering and is intended for painting chassis components and other automotive parts.
Application
The surface must be dry, degreased and free from dirt, dust and other contaminants. The enamel is stirred until uniform throughout the entire volume of the container, after which the LCD-1 desiccant is introduced in an amount of 1.5-2% by weight of the enamel. Enamel MS 17 is applied over the primer AK-070, GF-021 or VL-02. Apply the enamel paint sprayer. It is possible to dilute the enamel to the working viscosity (18-20) using xylene or solvent. Work in personal protective equipment using a respirator and rubber gloves. It is forbidden to work near an open source of fire.
Specifications (MS-17)
| No | Name of the indicator | Value |
| one | Mass fraction of nonvolatile substances,% | 37-43 |
| 2 | Conditional viscosity on the VZ-246 (4) viscometer, with, not less | 35 |
| 3 | Milling degree, µm, not more | 35 |
| four | The appearance of the film | uniform smooth surface |
| five | Film strength at impact, cm, not less | thirty |
| 6 | Flexural elasticity of the film, mm, not more | 3 |
| 7 | Film hardness by pendulum device TML (A), relative units, not less | 0.2 |
| eight | Adhesion, points, not more | 2 |
| 9 | Hiding power of dried film, g / m2, not more than | 20 |
| ten | Gloss of film,%, not less | 35 |
| eleven | Drying time to degree 3 at a temperature of (20 ± 2) ° C not more than, min. | thirty |
