Enamel VL-515

Purpose (OHL-515)

The gas can be distilled at a temperature of 18–23 ° C. 10 ° C, mineral oils, hot water with a temperature of 90-95 ° C. It has increased adhesion to aluminum. In addition, hot drying coatings (at 120 ° C) have better durability and durability than cold drying coatings.

 

Application

 

The surface must be dry, degreased and free from dirt, dust, and corrosion. Enamel VL-515 can be applied with air brush and airless spraying, with a brush or roller. To use the solvent R-60 or R-7. The estimated enamel consumption is 100-120 g / m2, depending on the surface and environmental conditions. Work in personal protective equipment using a rubber gloves. To the workplace to ensure a constant flow of fresh air. It is forbidden to work.

 

Technical characteristics (VL-515)

 

No	The name of indicators	Norm
one	Film color	yellow, the shade is not normalized
2	The appearance of the film	after drying the film should be smooth, uniform, without extraneous inclusions
3	Mass fraction of non-toxic substances of the semifinished product of the primer,%	60 + 3
four	Viscometer at T (20 + 0.5) 0 С, s	20-28
five	Drying time to degree 3 at T (20 + 2) 0С, h, not more than	6
6	The degree of grinding semi-finished primer, µm, not more	50
7	Flexural elasticity of the film, mm, not more	five
eight	Film durability at the device, cm, not more	50
9	Film resistance at T (60+) С, h, at least, to action:
	Fuel	6
	Water	6
ten	Adhesion, points, not more	one