ImPulse single component acrylic

Properties:
good adhesion to porous surfaces: drywall, plaster, concrete, stone, brick, wood. Plastic. It is painted. Without smell. Does not apply to polyethylene, bitumen, rubber, materials that emit oils and solvents, surfaces that are under water.

Technical data

Color and texture	paste
Density	1.67 ± 0.05 g / cm3
Working temperature	+ 5 ° С / + 40 ° С
Film formation time	up to 15 minutes
Cure time	about 1 mm per day *
Allowable deformation	± 7.5%
PH value at 20 ° C	8.0 – 9.0
Heat resistance	-25 ° С / + 80 ° С
Storage temperature	+ 0 ° С / + 25 ° С
Shelf life	24 months
* depending on the layer thickness, temperature and air humidity.

Application:
clean, degrease and dry the surface. Trim the cartridge above the thread. Cut off the tip to the width of the seam and screw it onto the cartridge. Extrude with a pistol. Smoothing the seam with a soap and water solution is allowed.

Attention!
S2 Keep out of the reach of children. S24 / 25 Avoid contact with skin and eyes. S26 In case of contact with eyes, rinse immediately with plenty of water and seek medical advice. S51 Use only in well-ventilated areas.

Logistic information

packing	packaging	number on pallet	barcode	gross weight
plastic cartridge with tip and cap	cardboard box	120 boxes	pieces 4820085760000	pieces 0.000 kg
260 ml	12 pcs. In the box	1440 pcs.	drawer 482008576000	crate 0,000 kg

Notes.
It is recommended to protect the seam from exposure to water for 6 hours after application.