Products

Enamel PF-133
October 12, 2018
Enamel ML-12 “K”
October 12, 2018

Enamel PF-266 “luxury”

Type:  Enamel PF-266 “Lux” is a suspension of pigments in alkyd varnish with the addition of solvent, sikkativa and special additives.

 

Scope:  Enamel PF-266 is designed for high-quality finish painted and unpainted floors of wood, fiberboard, chipboard, as well as other wooden surfaces (including thresholds, baseboards, stairs, etc.) inside residential, residential and industrial premises. 

Categories: , , Tag:

Specifications

No The name of indicators Requirements TNPA
one Enamel coating color  Must be established within the RAL color catalogs or control color samples.
2 The appearance of the coating After drying, it should not be wetted.
3 According to the type VZ – 246 with a nozzle diameter of 4 mm (or VZ – 4), at a temperature of (20.0 ± 0.5) ° C, s 70 – 120
four Milling degree, µm, not more 40
five Mass fraction of nonvolatile substances,% 56 – 65
6 Drying time to degree 3, h, not more than, at a temperature: (20 ± 2) ° С: 24
7 Gloss of gloss covering meter FB – 2,%, not less 55
eight Hiding power of dried coating, g / m 2 , not more 110
9 Coating resistance to abrasion, kg / μm, not less 0.25
ten TML (pendulum A), usl. units, not less 0.13
eleven 0.5% detergent solution, at a temperature of (40 ± 2) ° C, at least, min ten
12 Covering service life under operating conditions: UHL2, years, not less
T2, years, not less
2
one

 

 

 

Benefits:

 

It has been repeated to repeat the use of liquid detergents;

 

provides a glossy finish; possesses good decorative and protective properties; one-component enamel, stable during storage

 

Enamel is ideal for painting wooden floors.

 

the service life of the coating is at least 2 years. Surface preparation: Unpainted wooden surface should be cleaned according to GOST 6456) and dust free. It can be used to reduce the amount of water, it can be cleaned with sanding sandpaper, it can be cleaned with sanding sandpaper.

 

It is necessary to remove the peeled-off coating, sand and dust the surface.

 

Enamel application conditions:

 

air temperature is not lower than 5 ° C;

 

relative air humidity not more than 80%;

 

moisture content of the painted surface – 8 – 10%.

 

 

 

Coating:  Before use, it is thoroughly mixed, if necessary, diluted with nefras-C4-150 / 200

(TU RB 100006485.147), white spirit (GOST 3134) and filtered through a layer of gauze. The wooden textures in 1 – 2 layers, on the new ones – in 2 – 3 layers. At a temperature of (80 ± 2) ° C, it is no more than 24 hours. After painting, strong mechanical effects should be avoided for 7 days.

 

The drying time is not more than 24 hours at a temperature of (80 ± 2) ° C and a relative humidity of not more than 80%. It is increased. After the previous layer has dried. After staining, strong mechanical effects should not be avoided for 7 days.

 

 

 

The consumption of  a single layer is 65 – 100 g / m², depending on the method of application. 

 

up